Solutions

Bar and plate

Aluminum blocks built in layers: flat sheets that separate the fluids, bars that close the edges and fins in between. It is the rugged build for oil and air coolers on heavy equipment.

Bar and plate
Cutaway of a bar and plate block: alternating layers of fin, parting sheet and closing bar at the edges.

How it is built

A turbulator fin sits between two parting sheets, and the sides of each layer are closed with solid bars. Layers alternate, one per fluid, and the whole block is brazed in the furnace. Tanks and connections are then welded on.

Why it pays off

Handles pressure and spikesSolid bars and sheets make a stiffer structure than a thin-tube core. It copes better with pressure, the pressure spikes of a hydraulic circuit and vibration.
Each side sized to its fluidThe fin on each side is chosen separately: more open for air, lower and more turbulent for oil. The unit is matched to both fluids, not just one.
Several circuits, one blockEngine coolant, oil and charge air can share one block, each in its own layers. That saves space, brackets and connections.
CompactThere is fin in every layer on both sides, so a lot of heat transfer surface fits in a small volume.

Where it works best

  • Hydraulic oil coolers
  • Compressor oil and air coolers
  • Heavy-duty charge air cooling
  • Combined coolant, oil and air packages

When another one fits better

It is heavier than an aluminum tube-and-fin core and, like any brazed core, hard to repair in the field. Its passages are narrow: it is not meant for dirty fluids or fluids carrying particles, which are easier to clean in a shell and tube unit.

Is this the
one you need?

Tell us the equipment and the conditions. A plant engineer gets back to you.WhatsApp +54 9 342 635-6566