Solutions

Plate heat exchangers

Corrugated metal plates pressed together, with the two fluids flowing through alternating channels. It takes little space for the heat it transfers.

Plate heat exchangers
Pack of corrugated plates with their gaskets, showing each fluid's alternating channels.

How it is built

Each plate has a corrugated pattern that spaces it from its neighbor and stirs the fluid. In gasketed units a frame clamps the pack with tie bolts and rubber gaskets steer each fluid into its channel. In brazed units the plates are joined in a furnace and need no gaskets.

Why it pays off

Very compactThe corrugations keep the flow turbulent between plates, which transfers a lot of heat per square meter. For the same duty it takes a fraction of the space of a shell and tube unit.
Close temperature approachWith the fluids in counterflow, one outlet can end up very close to the other's inlet temperature. That recovers heat other exchangers let slip away.
Opens up and expandsA gasketed unit comes apart so each plate can be inspected and cleaned. If you need more capacity later, plates can be added to the same frame, within what it allows.
Low hold-up volumeIt holds little fluid, so it fills quickly and responds quickly to load changes.

Where it works best

  • Water-to-water and water-to-glycol duty
  • Water-cooled oil coolers
  • Separating a closed loop from cooling tower water
  • Heat recovery between clean process liquids

When another one fits better

The channels are narrow: it is not for fluids with solids, fibers or heavy fouling. Gaskets limit pressure and temperature, and their rubber must be compatible with the fluid; a brazed unit cannot be opened for cleaning.

Is this the
one you need?

Tell us the equipment and the conditions. A plant engineer gets back to you.WhatsApp +54 9 342 635-6566